Digisol DG-FS4526 - Clear Counters; Show Interfaces Status

DG-FS4526 User Manual
4-157
4
www.digisol.com
Example
The following shows how to enable broadcast storm control for port 5.
clear counters
This command clears statistics on an interface.
Syntax
clear counters interface
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-26)
• port-channel channel-id (Range: 1-12)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Statistics are only initialized for a power reset. This command sets the base
value for displayed statistics to zero for the current management session.
However, if you log out and back into the management interface, the statistics
displayed will show the absolute value accumulated since the last power reset.
Example
The following example clears statistics on port 5.
show interfaces status
This command displays the status for an interface.
Syntax
show interfaces status [interface]
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-26)
Console(config)#interface ethernet 1/5
Console(config-if)#switchport broadcast
Console(config-if)#
Console#clear counters ethernet 1/5
Console#