Digisol DG-FS4526 - Rcommand; Show Cluster

DG-FS4526 User Manual
4-317
4
www.digisol.com
rcommand
This command provides access to a cluster Member CLI for configuration.
Syntax
rcommand id <member-id>
member-id - The ID number of the Member switch. (Range: 1-36)
Command Mode
Privileged Exec
Command Usage
• This command only operates through a Telnet connection to the Commander
switch. Managing cluster Members using the local console CLI on the
Commander is not supported.
• There is no need to enter the username and password for access to the
Member switch CLI
.
Example
show cluster
This command shows the switch clustering configuration.
Command Mode
Privileged Exec
Example
Vty-0#rcommand id 1
CLI session with the DG-FS4552 Switch is opened.
To end the CLI session, enter [Exit].
Vty-0#
Console#show cluster
Role: commander
Interval heartbeat: 30
Heartbeat loss count: 3
Number of Members: 1
Number of Candidates: 2
Console#