Digisol DG-FS4526 - Show Upnp; Upnp Device Advertise Duration

Command Line Interface
4-320
4
www.digisol.com
Example
In the following example, the TTL is set to 6.
upnp device advertise duration
This command sets the duration for which a device will advertise its presence on the
local network.
Syntax
upnp device advertise duration {value}
value - A time out value expressed in seconds. (Range: 6-86400 seconds)
Default Setting
100 seconds
Command Mode
Global Configuration
Example
In the following example, the device advertise duration is set to 200 seconds.
Related Commands
upnp device ttl (4-319)
show upnp
This command displays the UPnP management status and time out settings.
Command Mode
Privileged Exec
Example
Console(config)#upnp device ttl 6
Console(config)#
Console(config)#upnp device advertise duration 200
Console(config)#
Console#show upnp
UPnP global settings:
Status: Enabled
Advertise duration: 200
TTL: 20
Console#