DG-GS1528HP/C User Manual
30
Figure 33 a shared body of SNMP configuration page
（2）TRAP target configuration page
Figure 34 is the TRAP target configuration page that allows users to configure the workstation to receive TRAP
messages as well as the IP address of TRAP protocol packets of some of the parameters.
In the configuration entry, the name used to enter the TRAP name, IP address used to enter the target address,
SNMP version used to select the version of the TRAP packet, if you set successful, it will show in the state to active. If
the configuration was successful, SNMP TRAP functions will take effects in the event of link up or link down, the
switch will automatically send a TRAP packet to the target address.
Figure 34 TRAP target configuration page
To Next Page
Loading...
