Digital-Ally FirstVu HD - Page 34

Digital Ally, Inc. | Regulatory
10-1
FirstVu HD Operation Guide | 860-00177-00 Rev J
Go Back To Table of Contents
Section 10
Regulatory
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the user equipment and FirstVu HD.
• Connect the user equipment into an outlet on a circuit dierent from
that to which the FirstVu HD is connected.
• Contact Digital Ally technical support.
This device complies with Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes
: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
The CE Mark is a European marking of conformity indicating that a product complies
with the essential requirements of the applicable European laws or Directives with
respect to safety, health, environment, and consumer protection.
Changes or modications not expressly approved by Digital Ally, Inc. could void the
user’s authority to operate the equipment.