Digital-Ally FirstVu HD - Setting the Date and Time Manually

Digital Ally, Inc. | Getting Started
2-3
FirstVu HD Operation Guide | 860-00177-00 Rev J
Go Back To Table of Contents
Setting the date and time manually
The date and time is set by the factory prior to shipment and should not need manual
adjustment. However, date and time can still be set manually if needed. Follow the
procedure below to manually set the date and time.
1. Open Notepad from your computer.
2. In Notepad, type in the year, month, day, hour, and seconds you
wish to program into the FirstVu HD. Use the following format
(YYYYMMDDHHMMSS) using 24 hour UTC time. You must also apply
your time zone oset. For example, If you live in the CST zone and
the current date & time is 5/23/2017 10:47:50pm, you would enter
20170524044750. Since CST is UTC-6, you have to add 6 hours to the
current time to reect the UTC time.
3. Go to File > Save As and name the le “DATE.txt”
4. Connect your FirstVu HD via the supplied USB cable and transfer the
DATE.txt le to the root drive.
5. Cycle the power on your FirstVu HD. The unit will apply the system
date/time during boot up. When completed, the FirstVu HD will erase
the .txt le.