- 53 -
P.B. Mode is Set to 5
The first function for Button 2 is to set the
Transbrake solenoid. When the button is pressed the
Transbrake will engage, however on the release of the button
the timing is started.
There is no second or third function for Button 2 in
Pro Mode.
Tap Button Settings
When in Bracket Mode
Any P.B. Mode
The first function for the Tap button is to set the
S.L.E. so the vehicle can be staged with the gas pedal fully
depressed. The S.L.E. feature is explained on page 33.
The second function for the Tap button is to Tap
Down, allowing time to be subtracted from the first delay
started. The Tap Down feature is explained on page 28.
The third function for the Tap button is to activate the
P.T.S.O., a Timer 1 Tap feature. The P.T.S.O. feature is
explained on page 35.
When in Pro Mode
Any P.B. Mode
The first function for the Tap button is to set the
S.L.E. so the vehicle can be staged with the gas pedal fully
depressed. The S.L.E. feature is explained on page 33.
The second function for the Tap button is to activate
the P.T.S.O., a Timer 1 Tap feature. The P.T.S.O. feature is
explained on page 35.
There is no third function for the Tap button in Pro
Mode.
To Next Page
Loading...
