Digital Projection E-Vision 6500 Series - In this Guide; Digital Projection E-Vision 6500 Seriesin this GUIDE; Computer 2; Signal Inputs and Outputs

Digital Projection E-Vision 6500 Series Signal Inputs And Outputs Connection Guide
15
Rev D July 2014
Signal Inputs And Outputs
Computer 1
• Connect an analog computer (VGA) cable to the 15-pin D-type.
Computer 2
• Connect a set of RGsB, RGBHV or YCbCr cables to the BNC connectors.
Computer 3
• Connect a DVI-I cable to the DVI connector.
Component
• Connect a set of YPbPr or YCbCr cables to the RCA phono connectors.
Video or S-Video
• Connect a composite video cable to the single RCA phono connector, or an S-Video
cable to the 4-pin mini-DIN.
Monitor Out
• Connect an analog monitor (VGA) cable to the 15-pin D-type.
COMPONENT
Notes
For a complete listing of pin
congurationsforallsignaland
control connectors, see Wiring
Details later in this Guide.
When Standby Mode is set to Eco:
the Monitor Out connection is
disabled.
COMPUTER 3
COMPUTER 1
COMPUTER 2
VIDEO &
S-VIDEO
MONITOR
OUT
LENS SHIFT
ZOOM
–
FOCUS
+
MENU
ENTER
RETURN
SOURCE
POWER
WARNING
LAMP1
LAMP2
AUTO