Digital Projection E-Vision 6500 Series - Setup Menu; Auto Search; Auto Power off; Auto Power on

Digital Projection E-Vision 6500 Series A Tour Of The Menus Operating Guide
Page 37
Rev D July 2014
Setup menu
Auto Search
• When this is set to On, the projector will search for an alternative input source when the
current input source is disconnected
• When this is set to Off, the projector will show the ‘background’ screen when the current
input source is disconnected.
Auto Power Off
• Set this to On, if you want the projector to go into Standby mode when no input source
is detected for 20 minutes.
Auto Power On
• Set this to On, if you want the projector to start up immediately when the mains is
connected.
• Set this to Off, if you want the projector to go into Standby mode when the mains is
connected. In this case, the projector will not start up until the POWER button is pressed
on the control panel or the remote control.
Standby Mode
• Set this to Standard or Eco as required.
MENU = END | SEL/ADJ. | SEL.
SetupVideo
Installation
SignalPicture
Standard
OnAuto Search
Auto Power Off
Auto Power On
Standby Mode
Background
Advance Setting
Aspect Ratio
3D Mode
On
On
Logo
Normal
Notes
See also Using the Menus, earlier
in this guide and Menu Map, later in
this guide.
To set the background screen, see
the next page.
When Standby Mode is set to Eco:
the Monitor Out signal is disabled,
and the RS232 connection is
disabled, so it will not be possible
to turn the projector On remotely,
except via the LAN connection.