Digital Projection E-Vision 6500 Series - Control Connections; Screen Trigger Output; RS232 Serial Control Input; Wired Remote Control Connection

Digital Projection E-Vision 6500 Series Wiring Details Connection Guide
23
Rev D July 2014
Control connections
Screen Trigger output
3.5mm mini jack
Tip 12V output
Sleeve Ground
RS232 Serial control input
1 unused
2 Received Data (RX)
3 Transmitted Data (TX)
4 unused
5 Signal Ground
6 unused
7 unused
8 unused
9 unused
Null-modem cable
(used to connect the projector to a computer)
RX 2 --- 3 TX
TX 3 --- 2 RX
GND 5 --- 5 GND
Wired remote control connection
3.5mm mini jack
Tip Not connected
Ring Signal
Sleeve Ground
pin view of female connector
Notes
Only one remote connection can
be used at any one time. For more
information, see the Installation
menu in the Operating Guide.
The projector is a DTE, so use:
a straight cable to connect to a
modem, or
a null-modem cable as shown here
to connect to another DTE such as a
computer.
Sleeve
Tip
Sleeve
Ring
Tip
1
9876
5432