Digital Projection E-Vision 6500 Series - Reset; Information

Digital Projection E-Vision 6500 Series A Tour Of The Menus Operating Guide
Page 44
Rev D July 2014
• When the warning message appears, use or to move the green highlight to
YES or NO, then press ENTER to conrm your selection.
Reset
All Reset
• Projector will ask for conrmation before restoring all settings to factory defaults.
• When the warning message appears, use or to select YES or NO, then press
ENTER/SELECT to conrm your selection.
Filter Timer Reset
• Projector will ask for conrmation before resetting the timer to zero.
• When the warning message appears, use or to select YES or NO, then press
ENTER/SELECT to conrm your selection.
Information
• The nal submenu gives information about the projector, eg:
Notes
Do NOT do this unless you are
sure that you want to restore ALL
settings to their factory defaults.
Do NOT do this unless you are
sure that you want to reset the
Filter Timer to zero.
Installation Menu
Information submenu
MENU = END
SetupVideo
Installation
SignalPicture
Input
Signal Info
Lamp 1 Timer
Lamp 2 Timer
Filter Timer
Information
[0000] h
COMPUTER1
Model Name E-Vision 6500 WXGA
1024 x 768 @ 60Hz
[0000] h [00] min (100%)
[0000] h [00] min (100%)
S/N C202XXXX00764
Software Version E-Vision 6500 WXGA - PO2/4S
Installation menu continued