Digital Stream DTX9900 - Electrical Safety and Product Care; Object Entry, Servicing, and Grounding

EXAMPLE OF
ANTENNA GROUNDING
GROUND CLAMPS
POWER SERVICE GROUNDING.
ELECTRODE SYSTEM
(NEC ART 350, PART H)
ANTENNA
LEAD IN WIRE
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING
CONDUCTORS
(NEC SECTION 810-21)
18) Object and Liquid Entry - Never push objects of any kind into this product through openings as they
may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never
spill liquid of any kind on the product.
19) Servicing - Do not attempt to service this product yourself as opening or removing covers may expose
you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
20) Damage Requiring Service. Unplug this product from the wall outlet and refer servicing to qualified
service personnel under the following
conditions: '
a) When the power-supply cord or plJg is damaged,
b) If liquid has been spilled, or objects have fallen into the product,
c) If the product has been exposed to rain or water,
d) If the product does not operate normally by following the operating instructions. Adjust only those
controls that are covered by the operating instructions as an improper adjustment of other controls
may result in damage and will often require extensive work by a qualified technician to restore the
product to its normal operation,
e) If the product has been dropped or damaged in any way, and
f) When the product exhibits a distinct change in performance - this indicates a need for service.
21) Replacement Parts - When replacement parts are required, be sure the service technician has used
replacement parts specified by the manufacturer or have the same characteristics as the original part.
Unauthorized substitutions may result in fire, electric shock, or other hazards.
22) Safety Check - Upon completion of any service or repairs to this product, ask the service technician to
perform safety checks to determine that the product is in proper operating condition.
23) Wall or Ceiling Mounting'- The product should be mounted to a wall or ceiling only as recommended
by the manufacturer. I .
24) Heat - The product should be situated away from heat sources such as radiators, heat registers,
stoves, or other products (including amplifiers) that produce heat.
25) The socket-outlet shall be installed near the equipment and shall be easily accessible.
26) When used outside of the U.S., it may be used HAR cord with fittings of an approved agency is employed.
27) Do not install this equipment in a confined space such as a book case or similar unit.
Allow adequate air circulation around this product.
28) Relevant label is attached on the bottom of this box.
02