To setup the DVR to check for new firmware automatically:
1. Select FTP from the METHOD drop-down options.
2. Make sure the FTP information is entered correctly (see section above).
3. Enter your convenient time at CHECK TIME and then click SAVE.
Video Signal
Check the right video signal (NTSC or PAL). Video images might heavily shake and blink if
NTSC/PAL is not properly set.
IP Address
This shows the DVR’s current IP address. It can be set at MENU > NETWORK > NETWORK.
MAC Address
This shows the unique identity number for the DVR.
System Monitor
Monitor the system performance and condition.
Keypad Beep
The user can turn on or off the beeping sound of the keypad.
To Next Page
Loading...
