Chapter 4. Programming menu description
4.1. Activation of programming mode:
A new door phone outdoor station module does not contain Service PIN – SPIN code programmed in
advance, so during the first programming procedure the System will ask to enter the mentioned code.
During the first programming procedure enter *1002#. A note “SET PIN” and four horizontal dashes will
appear. Enter your secret SPIN code of 4 digits.
NOTE: don't lose SPIN code, otherwise it will be forbidden to make any programming actions; the
code could be renewed only at manufacturers’ or representatives’ service.
For programming mode activation enter *1002# and enter SPIN code.
If you enter a wrong SPIN code, try one more time. If you enter wrong SPIN code 3 times a programming
mode will be blocked for 5 minutes.
Programming mode could be activated using Service Tag.
For programming mode activation enter *1002# and attach Service Tag to the reader. After activation of
programming mode, browse the MENU by using buttons.
Button used for approving, button - for canceling operation or return back for one step.
Leaving programming mode:
The System will return to the duty mode automatically after 20 seconds from the latest action. Also you can
leave programming mode by pressing “Cancel”.
4.2. Programming menu overview
Below is given quick programming menu overview. Fig. 11 shows menu structure.
15
ENTER CANCEL
ENTER CANCEL
To Next Page
Loading...