Making Connections
The Bass Whammy pedal is extremely easy to set up and use. Follow these steps to get up and
running.
1. Connect your instrument to the Bass Whammy’s
Input
Jack
.
2. Connect from the Bass Whammy’s
Output Jack
to your favorite distortion pedal or to
your amplier.
3. If using an external MIDI device for control, connect from the MIDI out of the MIDI
device to the Bass Whammy’s
MIDI Input.
4. Connect the included power supply to an AC outlet and the other end to the Bass
Whammy’s
Power Input.
5. Turn on your amp and adjust the volume to the desired level.
6. Use the
Eect On/O
Footswitch
to enable the eect, rotate the
Selector
Knob
to
select the desired eect, and rock the Expression pedal.
OCT 2OCT
OCT 10TH
OCT OCT
OCT 4TH
5TH OCT
5TH 5TH
To Next Page
Loading...
Need help?
General
