31
Section Four - Other Functions
Expression Pedal Assign
The Expression Pedal on the BP90 can be assigned in each preset to control the Volume, Wah,
DigiTech
®
Whammy
TM
, or one of several other parameters in real time with your foot. The proce-
dure for assigning a parameter to the Expression Pedal is as follows:
1. Press the Edit Up button until the Expression LED lights up. An effect LED will also light
indicating which effect the Expression Pedal is currently assigned to and the currently linked
parameter will be shown in the display.
2. Press the Value Up/Down buttons until the desired effect LED is lit (NOTE: the effect must
be turned on in the preset before it can be selected). The Expression LED will stay lit during
your selection and the Display will show a two-digit character value to describe the effect
parameter that the Expression Pedal is assigned to (see page 32).
3. Once you have assigned a parameter, you can set the control range of that parameter. Press
the Edit Up button again. The number value shown is the minimum parameter value – this is
the value that will be reached when the Expression Pedal is rocked back (heel down).
4. Press the Edit Up button again. The number value shown is the maximum parameter value –
this is the value that will be reached when the Expression Pedal is rocked forward (toe down).
5. Use the Store procedure (see page 17) to save your changes to the preset.
To Next Page
Loading...
Need help?
General
