Store the Preset
The last step that we need to do is to store our changes to a User Preset.If we changed Presets or turned the GNX1
off without storing these settings,it would forget what we had done and revert back to the original Preset.Press the
Store button once.The first letter in the Display begins to flash which is asking us to rename the Preset.Since this is
an example Preset,let’s name the Preset exampl.Press the Data Up/Down buttons until the flashing character in the
Display is an E.Press the Rhythm button once and the second character begins to flash. Use the Data Up/Down
buttons again until the flashing character is an X.Press the Rhythm button again to Select the third character and
change it to an A using the Data Up/Down buttons. Continue using the Rhythm button to select the characters and
the Data Up/Down buttons to change the characters.
Once the Display reads exampL,press the Store button again. Now the numbers in the red numeric Display are flash-
ing,which is asking where to store this new Preset.Using the Data Up/Down buttons,select 48 as the destination.
Press the Store button one more time to execute the Store function.
Congratulations! You have successfully created a Preset.
31
SECTION FOUR - TUTORIAL
To Next Page
Loading...
Need help?
General
