Flexible Output Modes
™
The Jimi Hendrix Experience™ pedal has three Flexible Output Modes:
Mono, Stereo Mixer and Stereo Amp.These modes let you send a mono
signal to an amp or mixer, or a stereo signal to two amps or two
channels of a mixer.
Mode 1 (MONO) is the default output mode when one cord is plugged
into either the OUT 1 (AMP) or OUT 2 (MIXER) output.
Mode 2 (STEREO MIXER) and Mode 3 (STEREO AMP) are enabled
when two cords are plugged into both the OUT 1 (AMP) and OUT 2
(MIXER) outputs. Mode 2 (STEREO MIXER) is the default stereo output
mode selected from the factory. Mode 3 (STEREO AMP) is enabled by
selecting STEREO AMP mode via the Flexible Output Mode Setup (see
the Selecting the Flexible Output Mode section). Once Mode 3
is selected, you can return to Mode 2 (STEREO MIXER) using the
Flexible Output Mode Setup.
Please refer to the Selecting the Flexible Output Mode section
for more information.
To Next Page
Loading...
