To Next Page

To Previous Page

Calibrating the Expression Pedal

1. Select Model 1 using the

MODEL

knob.

2. Press and hold the

HEEL SWITCH

for five seconds.The

INDICATOR LED

flashes green.

3.While the

INDICATOR LED

is flashing green, rock the

EXPRESSION PEDAL

all the way forward (toe down).

4. Select Model 2 using the

MODEL

knob. The

INDICATOR LED

flashes yellow.

5.While the

INDICATOR LED

is flashing yellow, rock the

EXPRESSION PEDAL

all the way back (toe up).

6. Select Model 3 using the

MODEL

knob. The

INDICATOR LED

should flash green three times and then turn off, indicating the

EXPRESSION PEDAL

has been successfully calibrated.

Note: If the calibration procedure fails, the INDICATOR LED will flash red

instead of green during step 6 and the unit will not return to normal operation

until the EXPRESSION PEDAL has been properly calibrated. Select Model 1

using the MODEL knob at this time and repeat steps 3-6 until expression pedal

calibration is successful.

JHE Manual v4.1 9/19/05 3:12 PM Page 23

DigiTech JIMI HENDRIX EXPERIENCE User Manual

Questions and Answers: