About the RP200 Artist
The Presets
Presets are named and numbered locations of programmed sounds which reside in the RP200
Artist. Presets are recalled with the Footswitches. The active effects in each Preset will be
indicated by the lighted LEDs in the Effect Matrix. The RP200 Artist comes with 40 User Presets
(Presets 1-40), 40 Factory Artist Presets (Presets 41-80),and 40 DigiTech factory presets (81-
120). The User Presets are locations where your creations may be stored. The Factory Artist
and Factory Presets will not allow you to store any changes to them. The 40 User Presets are
exact duplicates of the 40 Factory Artist Presets. This allows you to create your own Presets
without the worry of losing the sounds that came with the RP200 Artist.
Performance Mode
When you first apply power to the RP200 Artist, it will power up in Performance mode.
Performance mode provides access to all of the Presets within the RP200 Artist via the Up and
Down Footswitches.The Parameter 1 (left) knob will adjust the Amp Type, the Parameter
2 (middle) knob will select the Amp Gain (distortion), and the Parameter 3 (right) knob will
adjust the Master Level (volume).
Bypass Mode
The RP200 Artist Presets can be bypassed for a clean, unprocessed guitar tone.To bypass the
RP200 Artist, press both Footswitches simultaneously.The Display will read Bypass indicating
the Preset is bypassed.Pressing either Footswitch will exit Bypass and return the RP200 Artist
to the last Preset used.
9
To Next Page
Loading...
Need help?
General
