Tuner Mode
The Tuner in the RP200 Artist allows you to quickly tune or check the tuning on your guitar.
Enter Tuner mode by pressing and holding both Footswitches simultaneously.The Display will
briefly show TUNER indicating that you are in Tuner mode. To begin tuning,play a note on your
guitar (a harmonic at the 12th fret usually works best).The Display shows the note being played.
The Matrix LEDs indicate whether you are sharp or flat.The top 4 Red LEDs indicate the note
is sharp and should be tuned down.The bottom 4 Red LEDs indicate the note is flat and should
be tuned up.The center Green LED indicates the note is in tune. The output is muted in Tuner
mode.The Expression Pedal will control the guitar volume while tuning. Exit tuner mode by
pressing either Footswitch.
In Tuner mode, you can change your tuning reference.The default factory setting is A=440 Hz.
(displayed as A=440). Rotating the Parameter 1 knob will select alternate dropped tunings.
Alternate tunings are A = Ab ,A = G,and A = Gb. The display window will briefly flash the
current tuning reference.
10
To Next Page
Loading...
Need help?
General
