DigiTech RP200A - Chorus and Flanger Effects

Effects
The Effects row in the RP200 Artist is a multi-function module, allowing you to select effects
such as;Chorus, Flanger, Phaser,Tremolo,Panner,Vibrato,Rotary Speaker,YaYa™,AutoYa™,
SynthTalk™, Envelope Filter (auto wah),Detune, Pitch Shift,and Whammy™ effects. When the
Effects row is selected,the Parameter 1 knob is used to choose the type of Effect or turn the
Effect module off (eff Of).Only one of the effects in this row can be used at a time.After
selecting the type of effect in this module, the Parameter 2 and Parameter 3 knobs can then
be used to adjust the individual parameters associated with the selected effect.The following list
describes each Effect and their Parameters in more detail:
Chorus (CHORUS)
A Chorus adds a short delay to your signal.The delayed signal is modulated in and out of tune
and then mixed back with the original signal to create a thicker sound.
Amount -The Parameter 2 knob simultaneously adjusts the rate (Speed) and intensity
(Depth) of the modulation.Ranges from 1 to 99.
Level -The Parameter 3 knob controls the mix level of the Effect. Ranges from 0 to 99.
Flange (FLaNge)
A Flanger uses the same principle as a Chorus but uses a shorter delay time and adds
regeneration (or repeats) to the modulating delay.This results in an exaggerated up and down
sweeping motion to the effect.
Amount -The Parameter 2 knob simultaneously adjusts the rate (Speed) and intensity
(Depth) of the Effect.Ranges from 1 to 99.
Level -The Parameter 3 knob controls the mix level of the Effect. Ranges from 0 to 99.
20