1. Footswitches -These 2 Footswitches are used to select Presets,access the Tuner, or bypass
the RP200 Artist.The Footswitch on the right will increase,and the Footswitch
on the left will decrease the selected Preset.Pressing both Footswitches
together will bypass the currently selected Preset.Pressing and holding both
Footswitches will access the Tuner.
2. Parameter Knobs -The Parameter knobs perform various functions depending on which
mode is currently active in the RP200 Artist. In performance mode, these
knobs control the Amp Type,Gain, and Master Level.In Edit mode,these
knobs adjust the Parameter values listed directly above each knob for the
selected effect.When the Drum machine is enabled,these knobs control
the Pattern,Tempo,and Level.In Tuner mode,these knobs are used to
select the desired tuning reference.
3. Select Button -This button is used to enter the Edit mode, and to select individual effects to
be edited.Successive presses of this button will advance through all available
Effects.
4. Drums -The Drums button is used to turn on and off the drum machine.When the Drums
button is turned on,the Drums LED lights and the selected drum pattern plays
continuously. The Parameter knobs control the pattern,tempo, and level of the drum
machine at this time.
5. Matrix -The matrix provides information regarding the current Preset, and Parameter edit
functions.In performance mode,the LEDs running down the left side of the Matrix
will provide a visual indication of which effects are in use for the currently selected
Preset. In Edit mode,the LEDs indicate the Effect currently selected for editing. In
Tuner mode,the LEDs indicate whether the note played is sharp,flat, or in tune.
3
To Next Page
Loading...
Need help?
General
