DigiTech TONE DRIVER User Manual

Battery Replacement
1.Using the tip of a 1/4” guitar cable, push one of the release pins in on
either side of the pedal,and remove the pedal from the pedal chassis.
2.Remove the battery from the battery compartment and disconnect
the battery cable.
3.Connect a new battery to the battery cable and put it back in the
battery compartment. Make sure the battery cable does not interfere
with the spring or pedal switch arm.
4.Place one hole of the pedal over its corresponding pin.
5.Push the opposite pin in and lower the other side of the pedal into
place over the depressed pin. Release the pin. When the pedal is
properly fastened,both released pins are flush with the outer side of
the pedal.

DigiTech TONE DRIVER Specifications

Power

power_supply	9V Alkaline Dry Battery
power_consumption	4.8 Watts
optional_power_supply	PS200R - 100 (100V ~ 50/60Hz), PS200R - 120 (120V ~ 60Hz), PS200R - 230 (230V ~ 60Hz), PS200R - 240 (240V ~ 60Hz)

Impedance

input_impedance	280 kOhms
output_impedance	100 Ohms

Weight and Dimensions

weight	1.38 lbs
dimensions	4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H)