DigiTech TONE DRIVER User Manual

Connections
The Tone Driver has a single input (INPUT) and a pair of outputs (AMP
and MIXER). The two outputs give you the following options: running
into a guitar amplifier, or running directly to a mixing console or
recording device,or both. The MIXER output uses DigiTech’s advance
CIT™ cabinet modeling technology for an authentic guitar amplifier
sound without using an amp.
Follow these setup directions:
1.Turn the volume down on the amplifier/mixer you are connecting to.
2.Connect the pedal output to the amplifier/mixer input.
3.Connect the guitar to the pedal input.
4.Connect the power supply to the pedal (optional).
5.Turn the level control on the pedal to the minimum position.
6.Turn up your amplifier/mixer level to the desired listening level.
7.Turn on the pedal by pressing the pedal switch,and gradually turn up
the level to the desired listening level.

DigiTech TONE DRIVER Specifications

Power

power_supply	9V Alkaline Dry Battery
power_consumption	4.8 Watts
optional_power_supply	PS200R - 100 (100V ~ 50/60Hz), PS200R - 120 (120V ~ 60Hz), PS200R - 230 (230V ~ 60Hz), PS200R - 240 (240V ~ 60Hz)

Impedance

input_impedance	280 kOhms
output_impedance	100 Ohms

Weight and Dimensions

weight	1.38 lbs
dimensions	4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H)