DigiTech TONE DRIVER User Manual

7. Pedal Release Pins
These two pins are spring-loaded hinges that hold the pedal in place.
Push these pins in to release the pedal from the chassis exposing the
battery compartment. (See battery replacement diagram.)
8. Pedal
Turns the effect on and off.
9. Out 1(Amp) Jack
Connect this output to your guitar amplifier.
10. Indicator LED
Indicates when the effect is turned on. If the LED becomes dim or does
not light when the cables are connected,the battery needs to be
replaced.
11. Out 2 (Mixer) Jack
This output features DigiTech’s CIT™ cabinet modeling technology, that
lets you run the pedal directly into a mixer or recorder input without
having to use a guitar amplifier.

DigiTech TONE DRIVER Specifications

Power

power_supply	9V Alkaline Dry Battery
power_consumption	4.8 Watts
optional_power_supply	PS200R - 100 (100V ~ 50/60Hz), PS200R - 120 (120V ~ 60Hz), PS200R - 230 (230V ~ 60Hz), PS200R - 240 (240V ~ 60Hz)

Impedance

input_impedance	280 kOhms
output_impedance	100 Ohms

Weight and Dimensions

weight	1.38 lbs
dimensions	4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H)