33
Smpl Triggr Levl............Sets the level at which the audio signal will
trigger the sample. Variable from 0 to 100.
Smpl Direct Levl............Sets the level of the dry (non-effected) sound.
Variable from 1 to 100.
Smpl Start Point.............Determines the point at which the sample will
begin playing after it has been recorded. This
Parameter can be used to eliminate unwanted
sounds at the beginning of the sample, such
as empty space (silence), fret noise, amplifier
buzz, wrong notes, etc. Each time this
Parameter is changed, the sample is retrig-
gered. This allows easy editing of start sam-
ple points. This control can be set at any
point in the sample below the setting of SAM-
PLE END. Like the DELAY TIME Parameter in
delay Modules, this Parameter is controlled in
two ranges. Refer to the section in the own-
er’s manual on controlling the delay time of a
delay Module for explanation of the ranges.
Smpl Stop Point.............Determines the point at which the sample
stops playing. This Parameter can be used to
eliminate unwanted sounds from the end of
the sample. This Parameter can be set at any
point in the sample above the setting of SAM-
PLE START. Like the DELAY TIME Parameter
of delay Modules, this Parameter is controlled
in two ranges. Refer to the section on control-
ling the delay time of a delay Module for an
explanation of the ranges.
Section 4 - Effects and Parameters
Valve FX Owner’s Manual
To Next Page
Loading...
Need help?
General
