59
number, or you can change the MIDI channel(s) on which the
internal or external pedal will transmit MIDI CC messages to
other MIDI devices (using the MIDI Out port).
• To change the internal or external CC pedals’ default MIDI CC
number, press the appropriate Function key. Note that a cursor
appears under the value of the pedal you selected.
• Use the <UP / DOWN> Cursor keys or the Data wheel to
change the value as desired.
• Press <UTILITY> to return to your last position in the Program.
CC TRANSMIT CHANNEL This option allows you to set the MIDI channel on which CCs will be
sent out the Valve FX’s MIDI Out port to other MIDI devices. The CC
channel for Int Ped, Ext Ped and Toggle CCs may be set indepen-
dently. This option allows you to use CCs in the following three ways:
• For MIDI CC control of the Valve FX only
• For MIDI CC control of the Valve FX and other MIDI devices at
the same time
• For MIDI CC control of other MIDI devices only using the Control
One foot controller
If you are using CCs for control of the Valve FX only, you don’t need to
worry about setting up this option. If, however, you plan to use the
Control One foot controller for continuous control over other MIDI
devices (either in conjunction with the Valve FX or by themselves), it is
necessary to assign a MIDI transmit channel for each of the CC num-
bers you’ll be using for continuous control of the other devices. To
change the MIDI channels on which the selected CCs will transmit to
other MIDI devices, the procedure is as follows:
• From the Program, press the <UTILITY> key once. The display
reads:
• Press Function key 2. The display reads:
¡Patches ™CC Ped
£PrgList Assign≥
¡MIDI Contrst:4
™Foot £Tuner ≥
Section 5 - The Utility Menu
Valve FX Owner’s Manual
To Next Page
Loading...
Need help?
General
