To Next Page

To Previous Page

• From the Program, press the <UTILITY> key once. The display

reads:

• Press Function key 2. The display reads:

• Press Function key 2 once. The display reads:

• Press Function key 2. The display reads:

• Select whether you want to calibrate the internal (built-in) Control

One foot controller pedal or an externally connected pedal by

pressing the appropriate Function key. The display reads:

This step sets the maximum value of the CC pedal when it is in

the fully forward position.

• Move the pedal to its full forward (toe down) position and press

Function key 1. The display reads:

• Move the pedal to its full back (toe up) position and press

Function key 2. When the display returns to the Utility setup

menu, you have successfully calibrated the CC pedal.

• Press the <UTILITY> key to exit to your last position in the

Program.

Set Pedal Up

(Back), press ™

Set Pedal Down

(Forward) press¡

Calibrate Pedal

¡IntPed ™ExtPed

¡Assign Pedal CC

™Calibrate Pedal

¡Patches ™CC Ped

£PrgList Assign≥

¡MIDI Contrst:4

™Foot £Tuner ≥

Section 5 - The Utility Menu

Valve FX Owner’s Manual

DigiTech VALVEFX User Manual

Questions and Answers: