7
3.4 Frequently-used functions
3.4.1 Record
To record remotely, click “ ” or “ ” → “ ” to go to the “Record Setting” page.
In the “Record Setting” page, you can set the following items:
Record type
Pre- / post-event record time (0~10 seconds)
Record time setting
Record path
Note: The record function will be disabled when the reserved disk capacity in “Reserved(MB)” is larger
than the current disk capacity in “Free(MB)”.
When “Manual” is checked, click “ ” or “ ” on the main control panel to start the manual recording
immediately, and the recordings will be saved in the location specified in “Record Path”.
When “Motion” and / or “Alarm” are checked, the recording function will be enabled for any motion or alarm event,
and the recordings will be saved in the location specified in “Record Path”.
To Next Page
Loading...
Need help?
General
