26
4.8.5 Trigger
You can set the alarm or motion detection, and select the notification function.
Note: Motion detection is not supported when the streaming format is Motion JPEG.
Trigger Setting
In this section, you can select to enable or disable motion & alarm detection.
Item Description
Alarm Select to enable or disable the alarm function. When it’s enabled, go to “Alarm Input”
or Alarm Output” for alarm setup based on the alarm device you connected.
Motion Select to enable or disable the motion detection function.
‧ Motion Detection Area Setting
When “Enable” is selected, click “Detection” to enter the motion detection area
setting page as follows:
Level of Sensitivity:
Set the detection sensitivity: High / Normal / Low.
Area Setting:
Set the motion detection area by selecting the area grids with your mouse. Pink
grids represent the area that is not being detected while the transparent grids are
the area under detection. You can set multiple areas under detection.
Click “Clear All” to set the whole area undetected.
Click “Select All” to set the whole area under detection.
Trigger Duration Set the duration time for trigger recording (5 / 10 / 20 / 40 seconds).
To Next Page
Loading...
Need help?
General
