Need help?Do you have a question about the DIMOEL DIMO 700 and is the answer not in the manual?
24VDC electromechanical actuator for sectional/spring doors up to 2.25m and counterweight doors up to 2.45m, max area 8m².
Crucial safety points, installer responsibilities, and compliance with regulations.
Statement of conformity with relevant EC directives for the actuator series.
Specifies maximum heights and areas for sectional, spring, and counterweight doors.
Details when an accessory kit is needed based on measurement 'A' for proper installation.
Ensures the door is suitable, balanced, functional, and has an anti-fall system.
Visual guide showing the placement of the actuator, photocells, and socket.
Instructions for unfolding, connecting, and adjusting the guide section bar chain.
Steps for attaching the motor and performing initial setup and measurement.
Fastening the bracket to the door crossbeam and attaching the section bar.
Drilling and fastening ceiling brackets for the actuator, ensuring correct dimensions.
Guidance on assembling extension kits (p/n 163203) as needed.
Connecting draw slide/arm for sectional doors and manual actuator release.
Details on plugging in the control panel and connecting optional photocells.
Programming door limits, learning forces, and adjusting obstacle sensitivity.
Procedures for memorizing and erasing remote controls from the system.
Details frequency, power, modulation, current, and battery type for the remote.
Procedure for battery replacement, warnings, and FCC compliance information.
General| Max Gate Weight | 700 kg |
|---|---|
| Operating Voltage | 24V DC |
| Gate Width | Up to 5m |
| Control Type | Remote Control |
| Safety Features | Obstacle Detection |
To Next Page
