Dimplex BF33STP User Manual

6 www.dimplex.com
Operation
Figure 1
WARNING: This electric
rebox must be properly installed
before it is used.
Manual Controls
(Figure 1)
The controls for the Electric Fire-
place are located at the bottom
right hand corner of the unit.
CAUTION: Ensure that the
Voltage Selector switch is set
to the appropriate voltage
(115V or 230V)
A. On/Off Switch
The on/off switch energizes the
rebox and ame.
B. Mode Selector Switch
Select preferred feature:
• “o” for ame only
• “-“ for Purire
TM
only/ame.
• “=” for heat/Purire
TM
/ame
!
NOTE: The heater may emit
a slight, harmless odor when rst
used. This odor is a normal con-
dition caused by initial heating of
internal heater parts and will not
occur again.
C. Voltage Selector Switch
Needs to be set to reect the in-
coming voltage to the unit - 115V
or 230V.
Resetting The Temperature
Cutoff Switch
The heater on this replace is
protected with a safety device to
prevent overheating. Should the
heater overheat, the Overheat
indicator will be activated (Fig. 1),
and an automatic cutout will turn
the heater off and it will not come
Overheat
Indicator
Manual Controls
B. Mode
Selector Switch
A. On/Off
Switch
C. Voltage Selector
Switch

Dimplex BF33STP Specifications

General

Brand	Dimplex
Model	BF33STP
Category	Indoor Fireplace
Language	English