7
Operation
back on without being reset. It
can be reset by switching the On/
Off switch to OFF and waiting 5
minutes before switching it to ON.
The overheat cutout will be trig-
gered if the lter is dirty. Follow
lter maintenance.
CAUTION: If you need to
continuously reset the heater, dis-
connect power and call Dimplex
customer service at
(1-888-346-7539).
Remote Controls
An optional remote control can
be purchased to operate the
replace - BFRC-KIT. This
will allow the user the ability to
toggle through the three stages
of operation: Flames, Flames and
Purire
TM
, and Flames/ Purire
TM
/
Heat, with a remote control.
Wall Mounted Controls
The replace can be installed with
wall mounted controls. These
controls include wall switches
and thermostats. (see individual
installation guides for details)
1. Wall Mounted Switches
This model may be installed
so that a wall mounted switch
energizes the rebox and
ame, (On/Off Switch must
be in the ON position). A
wall mounted switch may
also be used to override the
ame image, (On/Off Switch
must be in the ON position
in coordination with any
main power wall mounted
switch). A wall mounted
switch may also be used
to override the heater/Puri-
re
TM
option (Mode Selector
Switch must be in the “=”
position).
2. Wall Mounted Thermostat
This unit may be installed so
that a wall mounted ther-
mostat can adjust the heat
temperature to your individual
requirements. Please refer
to thermostat manufacturers
operation Instructions. Mode
Selector Switch must be
set to “=” for thermostat to
control heater/Purire
TM
.
3. Wall Mounted Remote Controls
(WRCPF-KIT)
Dimplex manufactures a
optional wall mounted remote
control which allows the user
to fully control the replace
from a central location with
the added functionality of a
built in thermostat.
To Next Page
Loading...
Need help?
General
