Why is the flame not bright or not visible in my Dimplex BF5000 Indoor Fireplace?
If the flame in your Dimplex Indoor Fireplace is not bright or not visible, it could be due to burnt light bulbs (replace them). Other potential causes are loose wiring (check wiring connections) or a defective light harness (replace it).
Why does the heater fan run continuously on my Dimplex Indoor Fireplace?
If the heater fan in your Dimplex Indoor Fireplace runs continuously, it could be due to loose wiring (trace wiring in unit). Other potential causes include a defective heater on/off switch (replace it) or a defective heater assembly (replace it).
Why is the flame frozen on my Dimplex BF5000 Indoor Fireplace?
If the flame in your Dimplex Indoor Fireplace is frozen, it could be due to a defective flame motor (replace it). Another potential cause is loose wiring (check wiring connections).
What causes excessive noise with the heater on in Dimplex BF5000?
Excessive noise with the heater on in your Dimplex Indoor Fireplace could be caused by a dirty blower assembly (clean blower assembly) or a defective blower assembly (replace heater assembly).
Why is the log set dim and ember bed not glowing in my Dimplex BF5000 Indoor Fireplace?
If the log set is dim and the ember bed is not glowing in your Dimplex Indoor Fireplace, it's likely due to burnt light bulbs, which will need to be replaced.
What causes grinding noise when heater is off in Dimplex Indoor Fireplace?
Grinding or excessive noise with the heater off in your Dimplex Indoor Fireplace could be caused by the moving flame rod hitting or rubbing against internal components (flame rod replacement) or a defective flame motor (replace flame motor).
Controls all fireplace functions, including heater and flame.
Adjusts the speed of the flame effect to the desired level.
Adjusts the brightness of the flames and embers.
Powers the heating unit when the main ON/OFF switch is engaged.
Regulates room temperature by cycling the heater on and off based on setting.
Procedure and specifications for replacing upper bulbs illuminating the log set.
Instructions for installing the unit into an existing fireplace structure.
Guidelines for preparing a site for new wall construction.
General| Model Number | BF5000 |
|---|---|
| Type | Electric Fireplace |
| Voltage | 120V |
| Wattage | 1500W |
| BTUs | 5000 |
| Heater | Yes |
| Remote | Yes |
| Fuel Type | Electric |
| Flame Effect | Yes |
| Thermostat | Yes |
| Finish | Black |
| Heat Output | 5000 BTU |
To Next Page
