Dimplex DF2603 - Fireplace Insert Installation

10
2. Placethereplaceinthedesiredlocationtoseehowitwilllookin
theroom.
3. Foreaseofelectricalhookupyoumaywishtolocatethereplace
nearanexistingoutlet(refertoNOTE1).
4. Storethereplaceinasafedryanddustfreelocation.
5. Assemblethemantelsurroundkit(refertothemantelassembly
instructions)orconstructthecustomsurroundwithanopeningof
26½incheswideX23incheshigh(67.3cmwideX58.4cmhigh)
allowingadepthof12inches(30.5cm)(Figure4).
WARNING: Donotattempttowireyourownnewoutletsorcircuits.
Toreducetheriskofre,electricshockorinjurytopersons,always
usealicensedelectrician.
Fireplace Insert Installation
Thissectionprovideseasystepbystepinstructionsforinstallationof
yourreplace.
1. InstallTrimKittofrontofreplacebypositioningtrimthenpushing
straightforwardagainstthereplace.
2. MakesuretheunitisswitchedOff(refertoOperatinginstruction
section).
3. Plugthereplaceintoa15Amp/120Voltoutlet.Ifthecorddoes
not reach you may use a extension cord rated for a minimum of
1875Watts.
4. Pushthereplaceintoplacesothatthetrimisagainstthenished
MantelSurroundorwallsurface(Figure7)
5. Level,ifrequiredwithwoodshims(notincluded)(Figure8).
WARNING: Ensurethepowercordisnotinstalledsothatitis
pinched or against a sharp edge and ensure that the power cord is
stored or secured to avoid tripping or snagging to reduce the risk of
re,electricshockorinjurytopersons.