Dimplex DF2603 - Cleaning Procedures

16
5. Replacethelogbypushingitdownandinuntilitrestsagainstthe
mirror(Figure14).
Upper Light Bulb Requirements
Quantityoftwo(2)clearchandelierorcandelabrabulbswithanE-12
(small)socketbase,15Wattrating.Pleaserefertothelabeladjacent
totheupperlampsforthecorrectwattageforyourmodel.
CAUTION: Donotexceed25Wattsperlamp.
To replace the top light bulbs:
1. Locatethetwo(2)upperbulbsinsidethereboxatthetop.
2. Examinethebulbstodeterminewhichbulbsrequirereplacement.
3. Holdthesocketwhileunscrewingthebulb.
4. Holdthesocketwhilescrewinginthenewbulb.
To reassemble lamp area
1. Replacetheglassandholditinplaceatthetop(Figure12B).
2. Fastenretainingcliptoholdglassinplace(Figure12C).
Glass Cleaning
Theglassiscleanedinthefactoryduringtheassemblyoperation.
Duringshipment,installation,handling,etc.,thecleardoormaycollect
dustparticles;thesecanberemovedbydustinglightlywithacleandry
cloth.
Toremovengerprintsorothermarks,thecleardoorcanbecleaned
withadampcloth.Thecleardoorshouldbecompletelydriedwitha
lintfreeclothtopreventwaterspots.
CAUTION: Donotuseabrasivecleanersonglasssurfaceorspray
liquidsdirectlyontoanysurface.
Fireplace Surface Cleaning
Useaclothdampenedwithwarmwateronlytocleanpaintedsurfaces
oftheelectricreplace.Donotuseabrasivecleaners.