Dimplex DF3003 - Dimplex Mantel Surround Kit or Custom Made Mantel Surround; Fireplace Insert Installation

10
Option #1 -Thepowercordcanbeleadfrombehindthetrimand
 alongthewalltoanoutletnearthereplace.
Option #2 -Anewoutletcanbeinstalledinsidethenewframe
 construction.
DimplexMantelSurroundKitorCustomMadeMantel
Surround
1. Selectasuitablelocationthatisnotsusceptibletomoistureandis
awayfromdrapes,furnitureandhightrafc.
2. Placethereplaceinthedesiredlocationtoseehowitwilllookin
theroom.
3. Foreaseofelectricalhookupyoumaywishtolocatethereplace
nearanexistingoutlet(refertoNOTE1).
4. Storethereplaceinasafedryanddustfreelocation.
5. Assemblethemantelsurroundkit(refertothemantelassembly
instructions) or construct the custom surround with an opening of
303/4inch(78.1cm)wideX253/4inch(65.4cm)highX113/4
inch(29.8cm)deep(Figure3).
WARNING: Donotattempttowireyourownnewoutletsorcircuits.
Toreducetheriskofre,electricshockorinjurytopersons,always
usealicensedelectrician.
Fireplace Insert Installation
1. Makesuretheunit’sMainON/OFFswitchisswitchedOFF(referto
operatinginstructionsection).
2. Plugtheunitintoa15Amp/120Voltoutlet.Ifthecorddoesnot
reach,youmayuseanextensioncordratedforaminimumof1875
Watts.
3. Pushthereplaceintotheopeningbeingcarefulnottodamagethe
baseofthemantelorcabinetsothatthereplaceisushwiththe
mantelorcabinet.
4. Leveltheunitwithshimsifnecessary(notprovided).
5. Installthetrimontothereplace(refertotriminstallation
instructions).