Dimplex DF3003 - Remote Control

12
Level 1: Theameeffectisturnedonandtherstredindicatorlight
illuminates.
Level 2: Theameeffectremainson,theheaterisactivatedto
thelowheatsetting,andtherstandsecondredindicatorlights
illuminate.
Level 3: Theameeffectremainson,theheaterissettothehighheat
setting, and all three red indicators illuminate.
Resetting the Temperature Cutoff Switch
Shouldtheheateroverheat,anautomaticcutoutwillturntheheater
offanditwillnotcomebackonwithoutbeingreset.Itcanberesetby
switchingtheMainON/OFFSwitchtoOFFandwaitingve(5)minutes
beforeswitchingtheunitbackon.
CAUTION: Ifyouneedtocontinuouslyresettheheater,unplugthe
unitandcallDimplexNorthAmericaLimitedat1-888-346-7539.
Remote Control
Thereplaceissuppliedwitharadiofrequencyremotecontrol.This
remotecontrolhasarangeofapproximately50feet(15.25m),it
doesnothavetobepointedatthereplaceandcanpassthrough
mostobstacles(includingwalls).Itissuppliedwithoneof2,178
independentfrequenciestopreventinterferencewithotherunits.The
frequencydesignationisindicatedonthebackofthetransmitter.
Remote Control Initialization
Followsteps1through6toinitializeyourreplaceforthersttime.
Thisprocedureisalsorequiredeverytimethereisalossofpowerto
theremotecontrolinthereplace(I.E.powerfailure,breakertripped,
mainpowerswitchisturnedoff).
Level1Indicator
Level2Indicator
Level3Indicator
Figure 5