10
2. Locate the upper bulb bracket.
Bend light retainer bracket 3.
down.
Locate and remove the light 4.
bulb.
Insert new bulb.5.
Bend light retainer bracket 6.
back into its original position.
Close the door. 7.
Lower Light Bulb Requirements
or candelabra bulbs with an E-12
Lower Bulb Replacement
Open door by pulling the handle.1.
Remove the screw from the log set located in the center of the 2.
ember bed and remove the log set from the unit.
3.
replacement.
4.
5.
6.
Replace the log set retaining screw into the ember bed.7.
Close the door. 8.
Glass Cleaning
The clear door is cleaned in the factory during the assembly operation.
During shipment, installation, handling, etc., the clear door may collect
dust particles, these can be removed by dusting lightly with a clean dry
cloth.
with a damp cloth. The clear door should be completely dried with a
lint free cloth to prevent water spots. To prevent scratching, do not use
To Next Page
Loading...
Need help?
General