7
!
NOTE: A 15 Amp, 120 Volt circuit is required. A dedicated circuit is
preferred but not essential in all cases. A dedicated circuit will be
required if, after installation, the circuit breaker trips or fuse blows
on a regular basis when the heater is operating. Additional
appliances on the same circuit may exceed the current rating of the
circuit breaker.
WARNING: Ensure the power cord is not installed so that it is
pinched or against a sharp edge and ensure that the power cord
is stored or secured to avoid tripping or snagging to reduce the risk
Construction and electrical outlet wiring must comply with local
building codes and other applicable regulations to reduce the risk of
Do not attempt to wire your own new outlets or circuits. To reduce
licensed electrician.
Stove Installation
1.
operating instruction section).
Plug the unit into a 15 Amp/120 Volt outlet. If the cord does not 2.
reach, you may use an extension cord rated for a minimum of 1875
Watts.
Operation
To access the controls go to the back of
A. Three Position On/Off Switch
The switch has two On positions marked with
“-” and “=”. The “-” position is for manual
operation. In this position, the built-in remote
control is bypassed.
The “=” position is for operating the unit with the
provided remote control. When in “=” position the unit is operated with
the ON and OFF buttons of the remote control.
Figure 2
A
B C
To Next Page
Loading...
Need help?
General