16 www.dimplex.com
General
WARNING: The Revillusion
TM
Electric Fireplace must be installed
properly before it is used.
CAUTION: Except for installation
and cleaning described in this manual,
an authorized service representative
should perform any other servicing.
This fireplace operates with
ComfortSaver™ technology, which
automatically adjusts the fan speed
and heater wattage to safely and
precisely match the requirements of the
room based on the thermostat setting.
The heater operates such that once
the room reaches the set point, the
fan and heater will continuously run
at a low level to maintain the desired
room temperature. If the temperature in
the room rises significantly, (e.g., sun
coming through a window or a central
furnace turns on) the heater will turn
off and periodically turn back on to
circulate the air around the unit until the
room temperature drops and requires
the heater to be constantly on again.
NOTE: The replace retains heat
after shutdown. When the heat is
turned OFF, there is a 2-minute cool
down period before the fan shuts off
completely.
!
Touch Panel and Remote
Controls
The manual controls for the
Revillusion
TM
Electric Fireplace are
located on the front panel. Touch an
icon to activate. The selected setting
displays on the left side of the panel.
A multi-function remote control is
included. The remote control has a
range of approximately 30 ft (9 m). To
operate correctly, the remote control
must be pointed toward the front of the
electric fireplace.
Operation
To Next Page
Loading...
Need help?
General
