Dimplex XHD23L User Manual

11
Icon Function Description
A
Power
Press to turn unit off or on.
• Unit Off
Press to turn everything off. Press again to turn
unit on with previous settings.
• Unit On
Press to turn unit on with previous settings.
- If the flame effect was on, the flame will
turn on and the previous heat setting will
be activated (on or off). Display will show
current heater temperature setting and, after
2 seconds, the room temperature.
- [remote only] If the flame effect was off, the
previous heat setting will be activated (on or
off).
- [onboard only] If the flame effect was off,
the flame will turn on and the previous heat
setting will be activated (on or off)
B
Heat
• Heat On
Press to turn heat on (indicated by 1 short
beep). Display will show current heater
temperature setting and, after 2 seconds, the
room temperature. Use the Temperature icon to
change the heater temperature setting.
• Heat Off
Press to turn heat off (indicated by 1 short beep).
NOTE: After the heater is switched o󰀨, the fan will
continue on for 60 seconds before turning o󰀨.
C
Temperature
Press multiple times to cycle through the 12
temperature settings:
62°F, 64°F, 66°F, 68°F, 70°F,
72°F, 74°F, 76°F, 78°F, 80°F, 82°F, 84°F, On (
17°C,
18°C, 19°C, 20°C, 21°C, 22°C, 23°C, 24°C, 25°C,
26°C, 27°C, 28°C, On [continuous operation]).
Press once to display the set temperature. It will
flash for 3 seconds and then display the room
temperature.
Operation

Dimplex XHD23L Specifications

General

Brand	Dimplex
Model	XHD23L
Category	Indoor Fireplace
Language	English