OPERATING•WARNINGS
IMPORTANT: Remember to observe all safety warnings and precautions when operating the
heater on the automatic or timer modes, either attended or unattended since a fi re risk exists
when the heater is accidentally covered or obstructed.
Mains cables are not provided with this heater.
CAUTION: Do not use if either of the heater’s mains power leads become damaged. If the supply
cord is damaged it must be replaced by the installer or an approved Dimplex service partner.
Curtains must not come to within 250mm of the top of the heater.
Do not sit or stand on the heater
Do not place objects in contact with the heater.
To maintain stability, it is essential that the heater is placed on a level surface and care should
be taken to avoid irregular surfaces, such as may result from carpets or tiled surrounds
partially protruding under the heater.
ELECTRICAL•INSTALLATION
The•installation•of•the•heater•should•be•carried•out•by•trained•personnel.
WARNING•-•If•the•heater•is•installed•in•a•room•containing•a•bath•or•shower,•in•accordance•
with•the•current•wiring•regulations,•minimum•clearances•and•IP•zone•requirements•must•
be•adhered•to.•This•product•is•IPX4•rated.
WARNING - The electrical installation of this heater must be carried out by a suitably qualifi ed or
trained electrician, and be in strict accordance with current wiring Regulations. The peak supply
must be connected via a switched fused spur with a fuse rated suitably for the appliances ! ex,
the o" -peak supply , via a 20A double pole switch. Failure to follow these instructions will mean
that the manufacturer’s instructions have not been adhered to. THERE ARE NO EXCEPTIONS.
• This heater must be earthed
• Not suitable for connection via a plug top
• Do not locate the heater immediately above or below a • xed electrical point i.e. socket outlet.
This appliance is intended for installation to a single phase supply only.
The heater is not • tted with a mains cable, this should be • tted by the installer. Cable type
(minimum size) H05VV-F 1.5mm# three core for peak and 2.5mm# three core for o" -peak for
connection to the • xed wiring of the premises through suitable isolation devices positioned
adjacent to the heater. The supply circuits to the heater must incorporate a double pole isolating
switch having a contact separation of at least 3mm.
In installation the supply cord may be cut to the appropriate length for the electrical connection
point. Excess cable should not be inserted or stored behind the heater.
If, during reassembly of the heater, a part of the thermal insulation shows damage or deterioration,
it should be replaced by an identical part.
WARNING: All electrical connections to the terminal block must be secure to prevent risk of
ignition. Tighten to 0.5 Nm.
3
To Next Page
Loading...
Need help?
General
