21
Operation (continued)
J. Sleep Timer
The Sleep Timer can be set to
automatically shut off the replace
after a preset time (from 30 minutes
to 8 hours).
To set the timer press the
timer button on the remote,
repeatedly, until the desired
time is displayed.
The Display will display the different
times as it is adjusted. Once the
timer has begun, pressing the
button will display the time
remaining before the unit turns Off.
!
NOTE: The Sleep Timer can
be cancelled at any time
by pressing the button
repeatedly until the sleep timer
displays nothing.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the whole
unit off and it will not come back on
without being reset. If the button
on the unit is pressed, Er2 will be
displayed on the unit. It can be
reset by turning the unit off at the
main disconnect panel and waiting
5 minutes before turning the unit
back on.
CAUTION: If you need to
continuously reset the heater,
turn the unit off at the main
disconnect panel and call
technical support at 1-888-
346-7539.
Remote Control Battery
Replacement
To replace the battery:
1. Slide battery cover open on
the remote control.
2. Correctly install one 3 Volt
(CR2032 [longer life] or
CR2025) Battery in the battery
holder.
3. Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area
To Next Page
Loading...
Need help?
General
