Observe and Obey:
Common sense and planning must be
applied to control the movement of the
machine when lifting it with a crane or
forklift.
The transport vehicle must be parked on a
level surface.
The transport vehicle must be secured to
prevent rolling while the machine is being
loaded.
Be sure the vehicle capacity, loading
surfaces and chains or straps are sufficient
to withstand the machine weight. See the
serial label for the machine weight.
The machine must be on a level surface or
secured before releasing the brakes.
Brake Release Operation
1. Chock the wheels to prevent the machine
from rolling.
2. Pull out the red Emergency Stop button
on both the ground and platform controls
to the on position.
3. Press and hold lift switch to “down”
position in ground control, meanwhile turn
on the key switch to the "Ground" position.
The brake will be released after Alarm
alerts.
4. If you want to close the brake release, just
turn off the key switch in “ground” position.
Towing the Model is not recommended. If the
machine must be towed, do not exceed 4.0
km/h.
After the machine is loaded:
1 Push in both ground and platform red
Emergency Stop buttons to the off
position.
2 Turn the key switch to the off position.
3 Push the power switch to OFF position.
4 Chock the wheels to prevent the machine
from rolling.
To Next Page
Loading...
