OPERATOR’S MANUAL with Maintenance Information
Transport and Lifting Instructions
Securing to Truck or Trailer for
Transit
Always chock the machine wheels in
preparation for transport.
Turn the key switch to the off position and
remove the key before transporting.
Inspect the entire machine for loose or
unsecured items.
Securing the Chassis
Use the tie-down points on the chassis for
anchoring down to the transport surface.
Use a minimum of four chains or straps.
Use chains or straps of ample load capacity.
Adjust the rigging to prevent damage to the
chains.
Lifting the Machine with a
Forklift
Be sure the extension deck, controls and
component trays are secure.
Remove all loose items on the machine.
Fully lower the platform.
The platform must remain lowered during all
loading and transport procedures.
Position the forklift forks in position with the
forklift pockets.
Drive forward to the full extent of the forks.
Raise the machine 15 cm and then tilt the forks
back slightly to keep the machine secure.
Be sure the machine is level when lowering
the forks.
To Next Page
Loading...
Need help?
General
