OPERATOR’S MANUAL with Maintenance Information
Safety Rules
9
24V to charge the batteries.
The charger must match the battery. The
lithium battery cannot by the lead-acid battery
charger. The lead-acid battery cannot by the
lithium battery charger.
Pressure relief valves are used as breathable
plugs. If open the pressure relief valves, the
battery will be destroyed.
The battery must always be kept clean and dry
in order to prevent leakage currents. Do not
rinse with water or wipe with a wet towel.
Please do not change the location of the
battery, and cannot be inverted. Do not block
the vent hole of safety valve when placing.
Do not attempt to open or modify the battery in
any way.
The series/parallel connection must be
approved by Dingli. Only accessories
approved by Dingli can be used for connection
of battery blocks.
Electrocution/ Burn Hazard
Connect the battery charger to
a grounded, AC 3-wire
electrical outlet only.
Inspect daily for damaged
cords, cables and wires.
Replace damaged items before operating.
Metallic parts of the battery cells are always
electriferous. Therefore, no foreign objects or
tools may be placed on the batteries.
Avoid electrical shock from contact with
battery terminals. Remove all rings, watches
and other jewelry.
If the battery terminal is to be touched, it
should be operated with insulating gloves to
prevent the risk of high voltage electric shock.
Tip-over Hazard
Do not use batteries that weigh less than the
original equipment. Batteries are used as
counterweight and are critical to machine
stability.
The lithium battery: The battery must weigh a
minimum of 50 kg. (For JCPT0807HA/AC,
JCPT0808HA/AC, JCPT0812HA/AC,
JCPT1008HA/AC, and JCPT1012HA/AC); the
battery must weigh a minimum of 62 kg. (For
JCPT1212HA/AC, JCPT1412HA/AC, and
JCPT1612HA/AC, JCPT1612HAS/ACS).
The lead-acid battery: Each battery must
weigh 28 kg. The batteries must weigh a
minimum of 112 kg. (For JCPT0807HA/AC,
JCPT0808HA/AC, JCPT0812HA/AC,
JCPT1008HA/AC, JCPT1012HA/AC); Each
battery must weigh 30 kg. The batteries must
weigh a minimum of 120 kg (For
JCPT1212HA/AC); Each battery must weigh
37 kg. The batteries must weigh a minimum of
148 kg (For JCPT1412HA/AC,
JCPT1612HA/AC, JCPT1612HAS/ACS).
Lifting Hazard
Use the appropriate number of people and
proper lifting techniques when lifting hooks
must not cause any damage to cells,
connectors and connecting cables.
The lithium battery shall be operated s moothly
in the process of handling and assembly, and
collision and other impact phenomena are
strictly prohibited.
Environmental Hazard
30°C battery temperature is considered the
rated temperature. Higher temperatures
reduce the service life, while lower
temperatures reduce the available
capacity.45°C is the upper limit temperature
and is not permissible as an operating
temperature.
The rated temperature range of lithium battery
is-30℃～55℃.if it is found that the
temperature of the battery exceeds 60℃
during use, the battery should be stopped
To Next Page
Loading...
