OPERATOR’S MANUAL with Maintenance Information
Maintenance
82
All models:
18 Check each battery pack and verify that
the batteries are wired correctly.
19 Inspect the battery charger plug and pigtail
for damage or excessive insulation wear.
Replace as required.
20 Connect the battery charger to a properly
grounded 110 - 230V / 50 – 60 Hz single
phase AC power supply.
⊙ Result: The charger should operate and
begin charging the batteries.
¤ Result: If, simultaneously, the charger alarm
sounds and the LEDs blink, correct the
charger connections at the fuse and battery.
The charger will then operate correctly and
begin charging the batteries.
Note: For best results, use an extension of
adequate size with a length no longer than
15m.
The following must be measured and recorded
once the battery has been fully charged, after
a waiting time of at least 12 hours:
- Total voltage
- Individual voltage of the block battery
If significant changes to previous
measurements or differences between the
block batteries are identified, then customer
service must be contacted for further testing or
repairs.
Note: If you have any further questions
regarding the battery charger operation,
please contact the DINGLI Service
Department.
To Next Page
Loading...
