Dinolift 265RXT - Daily Maintenance Tasks

17
DINO RXT
3.1. DAILY MAINTENANCE TASKS
3.1.1. Condition of chassis, boom and work platform
Inspect visually the condition of access systems, work platform, platform gate and handrails.
Check that the chassis and boom have no visible signs of structural damage.
3.1.2. Check the tyres and tyre pressure
Inspecttheconditionoftyresvisuallyandchackthattheyarenotat.
3.1.3. Check the lights
Check all the warning and signal lights.
3.1.4. Check the hydraulic oil
Check the hydraulic oil level while the platform is in transport position. Add oil if needed.
Kyltin numero 30002A
Kyltinkoko(mm) 37x63R5
Pohjan väri valkoinen
Tekstin(kuvion)väri musta
Tekstin korkeus 3,5 mm
Materiaali tarramuovi
Kiinnitystapa oma liima
Kiinnitysalusta maalattu teräslevy
Käyttöpaikka DINO 180XT, DINO 210XT, DINO 260XT
Lisätietoja
The oil tank is located on the left side of the device.
3.1.5. Check the hydraulic hoses, pipes and connectors
Inspect the condition of hydraulic hoses, pipes and connections visually.
Make sure that there are no visible oil leaks.
Any externally damaged hoses or clashed pipes and connections must be changed.
3.1.6. Check the operation of safety limit switches
Test the correct operation of safety limit switches that prevent the boom and outrigger
movements unless the platform is in a correct position.
1. Platform must be in transport position, outriggers up.
2. Lift the boom from lower controls.
The boom must not work in any position of the control device.
3. Drive the outriggers down to operating position
4. Lift the boom so that the boom is not on the support
5. Drive the outriggers.
The outriggers must not work in any position of the control device.